Peugeot Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
81 Posts
Discussion Starter #1
Hi, i know its not the place to write here about remap but i have a problem, and hoping someone will answer quicker in here.

I bought a galletto 1260 to take the ecu file out get it remmaped and put it back. But the problem is that when trying to read the ecu it works fine - the green line goes quickly at the bottom, it means it can read it, but when trying to save file on my laptop it pops out with this message:

ATTENTION BEFORE TO CONTINUE: REMOVE FEEDING, PUT PIN 28 FLASH EPROM TO MASS, GIVE FEEDING AND REMOVE TO MASS PIN28 FLASH, END TO CONTINUE

I have no idea what to do with them pins, maybe someone had this problem and know how to make it work? Or maybe recommend someone who can do it?

Thank you
 
C

·
Guest
Joined
·
0 Posts
Can't help with that issue.

But I know galletto doesn't work with everything, some it reads and won't write too, others it'll write and won't read and some ecu's are just not compatible with it.
 
S

·
Guest
Joined
·
0 Posts
I also remember reading a few places that the siemens systems are a pig to remap

So with that in mind i wouldnt do anything until you get a definitave answer!
 
1 - 4 of 4 Posts
Top