Peugeot Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
hi all, great site need some help with a 307 hdi i got at the min bit of a nightmare it seems to have 2 problems that no one seems to know how to fix its been to dealership they didnt know and its been to a specialist who worked on them for 8 years and he couldnt figure it out!

What was happening is runs lovely give it a bit of stick on the motorway esp/asr fault engine management light comes on into limp mode, turn it off back on no esr light still got management light on not in limp mode 10 mins later in limp mode and so on. since the dealership had it it goes into limp mode just driving down the road at 20 mph.

the codes its got are:
Engine management: P1435- additive system
Particulate system: 2- low additive level sensor
ABS system: U1208- communication with the engine management ecu fault. value recieved incorrect.

2002 2.0 hdi RHS engine
95000 miles had full service
filter been cleaned new pressure sensor behind battery readings are spot on
filler cap working as it should do
filled tank with eolys fluid had counters reset
new turbo solenoid.

really appreciate any help or advise given :thumb:
 

·
Registered
Joined
·
8 Posts
Discussion Starter #3
thank you for the reply i would love to do away with it and wish i had done in the first place the money i spent on parts and labour could have done it by now do you think that all the trouble is with the fap system? what about the u1208 code any ideas what that could be? thanks again.
 

·
Registered
Joined
·
8 Posts
Discussion Starter #6
car is now fixed thank you magma1974 i removed the front bumper cleaned all the connections to the abs pump and no more esp light! and i removed the cap under the rear seat where fuel pump is and found some dodgy wiring that goes to th eolys tank sorted that no more engine management light result, thanks again.
 
1 - 6 of 6 Posts
Top