Peugeot Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
10 Posts
I am planning changing front brake discs and pads at the weekend so if you managed to find any videos could you forward a link pls
 

·
Moderator
Joined
·
11,775 Posts
According to the Haynes manual:

Take off the wheel, slacken and remove the two bolts securing the brake caliper to the hub (13mm spanner?).

Slide the assembly off the disk and tie it to the coil spring.

Mark the relationship of the disc to the hub then remove the screws securing the disc to the hub and remove.

If tight tap its rear face with a hide or plastic mallet.
 

·
Registered
Joined
·
90 Posts
I'm doing mine this weekend.

I can't see why you'd need to mark the position of the disc relative to the hub though - not seen it yet, but if there's a locating grub screw, then marking anything is unecessary IMO.

Got a few things to do this weekend, as I have new engine mounts (the one under the battery and the lower rear one) to do as well.
 
1 - 5 of 5 Posts
Top