Peugeot Forums banner

1 - 11 of 11 Posts

·
Registered
Joined
·
47 Posts
Discussion Starter #1
I have two peugeot 307s

Problems time - need some help on this one...
307 SW SXI 2.0 HDI 136 Bhp 2005

Upon a cold start the 307 is hard to start
Once started it smokes white smoke until warm

According to a diagnostic test - injector number 3 is overfuelling
The injectors are (siemens type) they have been replaced with no success.

When warm the car runs alittle rough - although when driven hard all is ok - loads of power - however slow low rev driving - the car jerks alittle bit

We are currently awaiting compression test results to see if we have a bent con rod on cylinder 3, blown head gasket - or leaking valves.

However, there does not appear to be any water or oil loss

Any Help would be appriciated
 

·
Registered
Joined
·
47 Posts
Discussion Starter #3
re turbo repeat sensor

hi - thanks for the reply, what does the sensor do ? - where is it and can it be tested - cheers stuart
 

·
Registered
Joined
·
47 Posts
Discussion Starter #4
Turbo repeat sensor

Hi I done some searching on the forum...

and found some refs to Turbo Repeat Sensor... causing juddering etc...

Would this cause the smoking on a cold start also ???

I have tried to contact some of the guys who posted these message re the sensor... but because i am a newbie.. it wont let me...

Any one with any info on this could save my relashionship (girlfriends car ! ) but more importantly the car ! :)
 

·
Registered
Joined
·
47 Posts
Discussion Starter #9
I hope this is a sensor issue - been quoted a grand+ for a new engine :eek:

still awaiting the compression test results..
 

·
Registered
Joined
·
47 Posts
Discussion Starter #10
Compression Test results

Compression test for the 307 HDI 2.0 16 valve 136 bhp

result all ok :thumb:

so what causing the smoky start :confused:

any ideas - thanks stuart
 

·
Registered
Joined
·
47 Posts
Discussion Starter #11
Fault Codes

OK we had the Fault codes back

p1351 - pre/post heater relay fault
p2031 - uknown
p1669 - ecu defect ?
p0269 - injector number 3 flow fault
p2563 - unknown
p0299 - unknown
p2563 - turbo repeat value incorrect


please any help in what to go for first or what the unknows are would be really helpfull

thanks stuart
 
1 - 11 of 11 Posts
Top