Peugeot Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
hi, i have a 307 1.6 hdi 2008 model have had power issues for about 1 year, garage has had it on a number occasions, first they thought it was gasket seals then egr valve, so had that changed aswell last week. still no success. could it be problem with turbo? takes forever just to get to 50 mph and feels like its struggling.
when taken egr valve off looked carbon up, and struggled to get just over 3000 revs but since after replacement of egr goes up to 4000 rev when stationary

Had it hooked in to diagbox today and came up with 2 issues-
1st- Bsi fault- f000 fault engine wiring housing: ecu mute on the can

2nd- BSM Fault- F000 Engine fuse box not communicating on the can fault


can this be the issue of no power? limp mode?

Any advice would be much appreciated.

thanks
 

·
Registered
Joined
·
14,860 Posts
I would say they may relate to an issue with Underbonnet fusebox as everything runs through the fusebox having said that im not sure it would affect engine running

Is it a 90hp or 110 if 110 check the vacuum levels to the control solenoid for turbo
 
1 - 2 of 2 Posts
Top