Peugeot Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi all. Need to replace input shaft bearing on my 2000 306HDI. Have the box off, but struggling with getting the pin out of the clutch arm. Lots of threads about how to do this on a Dturbo, but this doesn't seem applicable to the HDI. Looks like it's just a threaded stud on the HDI. Can it be got off by locking two nuts together on the thread? Doesn't seem to be enough thread sticking out to do this easily. Any tips gratefully received. Cheers
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top