Peugeot Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
Good morning , just need abit of help.
So my clutch pedal hit the floor the other day with no warning , I could not engage any gears.
So I mananged to get it back home in 2nd gear , luckily I was a couple miles .
away.
So there were no warnings my clutch was on it's way out , so I checked the clutch pedal , and pulled it by had , I. Noticed when pushing the clutch down it was easy until halfway and then felt a little bit of pressure , but still stuck to the floor, I also noticed that I could change gear with the clutch up not whilst the car was running , but stationary and turned off, it actually changed in every gear , any help would be appreciated.
 

·
Moderator
Joined
·
6,425 Posts
Sounds like master or slave cylinder fault. Check for leak from slave cylinder

Sent from my SM-G935F using Tapatalk
 

·
Registered
Joined
·
1,061 Posts
If your clutch is the later pull type, the release bearing may have detached from the pressure plate given the symptoms you describe.
No alternative but to replace the clutch if I am right - sorry not good news. Check the master and slave cylinders first, could be a hydraulic leak or low fluid.
 
1 - 3 of 3 Posts
Top