Peugeot Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1 (Edited)
changed my battery in my 207 3 button key fob then my remote locking and alarms don't work :have read on difference sites about disconnecting the battery and doing various measures does anyone know if this will work on this model
 

·
Registered
Joined
·
3 Posts
Discussion Starter #3
207 key 3 button fob

thanks shep64 I have tried that but it did not work thank you for the suggestion .I have seen a link where it talks about removing battery terminal for 10 mins then doing certain operations through the open drivers window I was hoping that this method would work on my 207 estate.???
 

·
Registered
Joined
·
202 Posts
Try this Pete.

Put key in ignition and turn it on fully WITHOUT starting.
Then press the locking button on the key for around 5 secs.
Turn off and remove key.
Wait around a minute and try your central locking.
 

·
Registered
Joined
·
362 Posts
When changing battery, it's usual to remove inadvertently the transponder (like a small square stone inside fob) or put it in a wrong position. Check if it is well located inside fob and try again.

Full procedure to synchronize fob:

-turn switch ignition to position ON (one position before start engine)
-Press and hold fob lock button for 10 seconds
-turn switch ignition to OFF position
-remove key from ignition switch
-wait 5 seconds
-try if locking/unlocking works using FOB

Hope it helps,

erick
 

·
Registered
Joined
·
4,784 Posts
When changing battery, it's usual to remove inadvertently the transponder (like a small square stone inside fob) or put it in a wrong position. Check if it is well located inside fob and try again.

Full procedure to synchronize fob:

-turn switch ignition to position ON (one position before start engine)
-Press and hold fob lock button for 10 seconds
-turn switch ignition to OFF position
-remove key from ignition switch
-wait 5 seconds
-try if locking/unlocking works using FOB

Hope it helps,

erick
if the above does not work try unplug the grey wire from comms unit and then plug it back in
 
1 - 7 of 7 Posts
Top