Peugeot Forums banner

1 - 11 of 11 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
Hi Gents,

Not sure on this one

I have the following code

P2408: EDC16C3 - Additive system. Fuel tank cap presence sensor.

I am getting the DPF removed and remapped tomorrow is there anywhere in
planet to remove this as the additive system will be made redudndant and I dont
want to fork out £70.00 for a sensor 1503AG or can I bridge the reed switch so it is always connected?

Thanks Steve
 

·
Registered
Joined
·
822 Posts
Just ignore it if you are removing dpf.
Though you might be able to tell bsi under configuration that it has a different type of fuel cap.
 

·
Registered
Joined
·
11 Posts
Discussion Starter #5
I don't but my mates garage who is doing it does any idea where to look I'm not that clued up om planet. thanks Steve
 

·
Registered
Joined
·
822 Posts
I think it will be in the bsi configuration.
are they remapping ecu as well to tell it that there is no longer dpf, if not you are likely to run into problems.
 

·
Moderator
Joined
·
6,434 Posts
EDC16 ecu has DPF control built in so no BSI config required proper remap should remove trouble code
 

·
Registered
Joined
·
5 Posts
about the cap sensor

hi there i have replaced my sensor but the code still as it is


what shall i do after replacing the sensor


i had the problem which was with you

dpf problem and sensor the car in limp mode


replaced the sensor but the error didn't go yet ?


and advice guys


thank you
 
1 - 11 of 11 Posts
Top