Peugeot Forums banner

1 - 15 of 15 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter #1
Hey,

I am having trouble with a 207 1.4 that will not start, It cranks over but will not fire While it cranks the battery light, check oil light and eco mode flash. The battery voltage and oil level is fine. There is fuel getting to the rail but there is no spark or fuel been injected all plugs are dry. Scanned it with PP and getting an imobilization error the fuel pump primes up ok tried a new crank sensor re programmed the keys and still it wont fire is there anything else that could be causing this to happen ? any help would be great cheers.
 

·
Registered
Joined
·
36 Posts
Discussion Starter #3
Hi thanks for reply is I've scanned it with peugeot planet will that not be good enough or does it need to be a proper dealer one ? Are the key transponders comon on these ?
 

·
Moderator
Joined
·
12,095 Posts
Perhaps show us the results of your diagnostic and the details of live data might show something, but that could result in a lot of screenshots.

With Planet its all about interpreting the information that's on the screen. Having the equipment is not much use if you can't use it!

Are there any members close to you who could help you use it, you've not put your location in your profile.
 

·
Registered
Joined
·
36 Posts
Discussion Starter #10
Ive had a play around with planet today, in the BSI unit there is an error code which is 37f4BA Immobilizing function key coding recognition. In live data I checked that the 4 digit code is the same as whats coded into the BSI this comes back as correct.

It also shows the there are 0 keys coded to the car when I try to re code them it fails every time I switch ignition off then turn it on and is fails. I have removed the BSI Unit and checked for any damage and it all looks fine. Is this looking like a possible key fault is there anywhere other than the dealers where I could get a key ?

In live data the ecu said it was unlocked but when I turn the ignition it goes to locked the BSI & ecu both say matched and transponder is sending signals will try get some screen shots up asap cheers for help so far.
 
1 - 15 of 15 Posts
Top