Peugeot Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi there,

i am trying to replace my 206 rear wiper arm. The metal collar in the hole where the arm attaches has become worn and perished over time. i have a new arm for it which i am assured is the correct part and is exactly the same as the old one. The new collar seems too small to fit on to the motor shaft as there is a knurled metal part to it which the collar does not fit over. Is there a way to take this knurled part off to slide the new arm onto the shaft?


cheers!!!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top