Peugeot Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
118 Posts
Discussion Starter · #1 ·
Hi,
Another problem - wipers.

My front wipers park well below their marks on the screen. So low in fact the drivers side is beow the windscreen rubber, leading to wear of both wiper and rubber seal.

Is there any way to adjust the park position of the wipers - moving it up by 2" on the screen?

Thak you.
 

·
Registered
Joined
·
118 Posts
Discussion Starter · #3 ·
bettyswollocks said:
are they not just held tight with a nut , loosen that move them up and tighten
I think they might be :rolleyes: As the NS one seems ok, it must just have rotated. I wonder if they even have splines ?
Either way - it needs a puller to get it off.

Cheers.
 

·
Registered
Joined
·
118 Posts
Discussion Starter · #4 ·
Fixed -

Off with a 2 legged puller, then 3 attempts to get it right.

Splines on the drive of the right spindle only !!!! - not even on the connecting bar, and no drive on the left spindle.

Any bit of ice and they will end up too low.

Bad design.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top