Peugeot Forums banner

206 1.4 HDI 2004, turbo problem?

18K views 6 replies 4 participants last post by  Mickyroo28  
#1 ·
Peugeot 206 1.4 HDI FEVER
2004 model

Recently i've had 1 injector replaced, coded in properly, all bled properly and was running fine

Couple of weeks later i had another issue, the leak off pipes decided to fail, so went to peugeot and ordered some new ones, fitted them, primed up etc, fired straight away (i re-seated the other 3 injectors with new seals and protectors while i was there as it was chuffing its nuts off)

But now i have another problem, its went into limp mode, wont rev past 3000rpm
and it seems like the turbo isnt even there.

plugged it in, comes up with P1160.
Had a boost gauge fitted to measure the boost, usually peaks at 1.5 bar roughly.
This time, 0.

Anyone shed any light on this?
 
#2 ·
Hello,

My car is doing the same.

I had a split turbo intake pipe and outlet pipe, these have been replaced. I also had the EGR cleaned, although I was told that these break 99% of the time when being cleaned. Does your engine warning light come on? Mine does, then the car has no power and does not rev past 3000rpm either. This fault seems to be intermittent, however even when the engine light is off and the car revs past 3000rpm there is still no power whatsoever. Driving anywhere with a hill is awfully slow. I have given my car to a mechanic to correct the problem. Have you had any luck with getting yours resolved?