Peugeot Forums banner

1 - 9 of 9 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hi, I've searched the forums thoroughly and the threads didn't quite help enough. I've fitted steel springs and now need help disabling the air suspension in Diagbox. I have version 7.62 but I cannot find the BSI setting for normal/air sus. I can disable the the air sus ecu, test all the air input/output solenoids, but not find the option to change the basic type. Can anyone help? Many thanks in advance.

Sent from my VFD 900 using Tapatalk
 

·
Registered
Joined
·
14,916 Posts
It should not really be necessary to disable it but it will be in BSI configuration of options somewhere IF you are able to do it.

I have seen it show up on some cars depends on vehicle and version of diagnostic software you are using as to where it is every version is different.
 

·
Registered
Joined
·
4 Posts
Discussion Starter #3
Thanks for reply. I want to get rid of the "suspension faulty" message on start up and the permanent dash light. It throws these when it realises there is something amiss (ie no air springs). Tried PP2000 as well but fewer options available in that, as you'd expect. I've read of dealers being able to do it for a fee, but seeing as I've shelled out for Lexia...

Sent from my VFD 900 using Tapatalk
 

·
Registered
Joined
·
9 Posts
Hi sorry cant reply to pms as dont use this site much, erm the suspension bit I cant remember where it is pretty sure its on the configuration page of the bsi but been a while since I did it to my mates taxi, I cant remember if you have to go in through repair or faultfinding to get to the page honestly we just went through each page untill we found it as we was new to lexia back then as well so kinda lucky to find it. Sorry I cant be more help
 

·
Registered
Joined
·
4 Posts
Discussion Starter #5
Cheers, will continue to root around the menus tonight.

Sent from my VFD 900 using Tapatalk
 

·
Registered
Joined
·
9 Posts
Hi, I've searched the forums thoroughly and the threads didn't quite help enough. I've fitted steel springs and now need help disabling the air suspension in Diagbox. I have version 7.62 but I cannot find the BSI setting for normal/air sus. I can disable the the air sus ecu, test all the air input/output solenoids, but not find the option to change the basic type. Can anyone help? Many thanks in advance.

Sent from my VFD 900 using Tapatalk
Hi did you manage to sort the fault? have the same problem with mine
Cheers in advance Billy
 

·
Registered
Joined
·
4 Posts
Discussion Starter #7
Hi did you manage to sort the fault? have the same problem with mine
Cheers in advance Billy
Hi, unfortunately not. From what I could gather it is a dealer only activity. Gave up in the end. Sorry I can't help you any further.

Sent from my VFD 900 using Tapatalk
 

·
Registered
Joined
·
9 Posts
Hi, unfortunately not. From what I could gather it is a dealer only activity. Gave up in the end. Sorry I can't help you any further.

Sent from my VFD 900 using Tapatalk
No worries gonna didg a bit into this and i will let you know how i get on
 
1 - 9 of 9 Posts
Top