Peugeot Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi
I have an issue that appeared after a week or so of getting our 1007 cars been running without fault no issues starting or running no errors or apparent engine or electrical faults very pleased with it till this popped up. Returning home car started on the button drove around 6 miles then on leaving a roundabout Antipollution fault popped up and car went into limp mode. I managed to get it to a lay-by tried the power off and on but after an hour gave up had the car picked up and here I am. I have an error code of P0608 VSS error. The car starts runs I have no throttle input the revs pulse between 1200-2000 when under load from the aircon being switched on and off. I have checked all the pipe work cleaned the map sensor and unplugged and checked all the connections around the inlet side. Completed a BSI RESET AND throttle teach the cars has only covered 57k and is in what seems to be well looked after new air filter no oil leaks. Only had the car 2 weeks
 
1 - 1 of 1 Posts
Top