Hi there, i have a 2002 Peugeot 307 2.0L thats giving me a P0106 fault code, the engine doesnt idle, blows black smoke, backfires etc etc, i have replaced the MAP sensor with no change to engine performance, have then gone a little deeper to check power to the MAP sensor, i have a 5v signal wire and earth and the third wire is giving me 11v when the ignition is on, is this normal? Also when my scanner is plugged in, the key is on and the engine is not running i get a reading of 100KPA for the MAP sensor which is normal but when the engine is running it goes up to 105KPA, shouldnt it be around 50KPA? Any help your be greatly appreciated!!
If those figures are absolute then they seem ok. 105kpa is just over 15 psi which is fine as you will get slight boost even at idle.
Based on you symptoms I would check EGR valve first they are mechanical on that age so often give no direct codes only related code for air flow and boost pressure being too high or low etc
Miss read post though it was diesel still worth a egr check
Hi, thanks for your reply, I did not think of the EGR valve, do you know where to find it on the engine? I’ve tried googling it but nothing can confirm it’s location.
Checked EGR but all looks to be fine, could anyone with the same vehicle mind checking to see what voltages they have at the MAP sensor, am wondering if the ECU is buggered!
A bit of history on the car would help. Did this just start happening after you have had the car a fair amount of time or have you just got the car with the fault? ECU's very rarely just fail. When you said checked EGR what exactly did you do as the check?
I brought the car with the issue, have had a little progress now, i did a smoke test on the engine and found that the intake butterfly shaft seals were leaking, i put in a second hand throttle body which has now fixed half the issue, the engine now idles and runs a lot smoother, the map sensor is reading correctly, new fault has come up now for the fuel trim bank 1 and o2 sensor heater, before replacing the o2 sensor im trying to find a engine wiring diagramme to see where the o2 sensors go to incase theres a relay or something.
Am having same problem.Running really rough.Backfired once really loud.
PP2000 P0107 and P1160.Short circuit to earth.
Tested volts at MAP sensor and getting 1.5 to 2 volts.
Am now looking towards the ECU to test but do not know which plug or wire number to look at.
Any advice would be appreciated.
Thanks
Unfortunately Burky has hijacked your thread which does not help you or us!
Anyway the Haynes manual only shows the coolant circuit for some strange reason.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Peugeot Forums
609.6K posts
336.7K members
Since 2005
A forum community dedicated for all Peugeot owners and enthusiasts. Come join the discussion about performance, reviews, reliability, modifications, troubleshooting, maintenance, for all models.