Peugeot Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
3,426 Posts
Discussion Starter #1
On my 2.0 hdi there's coolant pipes to the airbox these are a pain to get the box out

I,m doing my clutch soon so I'd rather deal with this when the coolants emptied has anyone re routed if so any pics
 

·
Moderator
Joined
·
5,830 Posts
If you have mapped out DPF just replace T piece with a straight connector on feed from top of engine. Then replace bottom rad hose with 90 BHP type or cut tee off hose back and plug end with suitable blanking plug (I think I used a 15mm Yorkshire stop end and a jubilee clip.

You can then throw away matrix from airbox and blank hole with a piece of plastic (roller tray from poundland works well)

If not mapped you can remove the six small torx screws and slide matrix out of airbox and tie to bottom hose to work on car etc and the replace after
 
1 - 2 of 2 Posts
Top