Peugeot Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
Hi all,

My 2001 1.1 106 has recently had a head gasket replacement and has been sitting the best part of a year. It usually starts first time but it runs very roughly and will not idle, it just slowly stalls, sometimes immediately. I have replaced the coils and stepper motor but have had no success as of yet. Any suggestions? All tips and answers welcome.

Thanks,

Iain
 

·
Moderator
Joined
·
8,440 Posts
Have you cleaned the throttle body as well as change the motor
 

·
Moderator
Joined
·
8,440 Posts
You said you changed stepper motor
 

·
Registered
Joined
·
10 Posts
Discussion Starter · #8 ·
I removed the air filter box as where the crankcase breather hose fits has been snapped off and replaced a bit of garden hose pipe and tape, and discovered whilst doing so that the coolant temperature sensor was unplugged! I've got a fresh container of petrol for it and will report back once new air filter arrives. Strange that that didn't trigger any codes or lights though.
 
1 - 8 of 8 Posts
Top