Peugeot Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi we have a 1.4 1007 semi auto in, it wasnt starting so we code read engine management with no codes stored, and then code read gearbox which had the following codes,
2 incorrect transmission ratio (slip)
0 kick down switch
4 gearbox oil temperature sensor circuit
when we cleared the code you could hear the car trying to select a gear and then eventually the number 1 flashed on the dash and we could start the car but when we selected the gear it just didn't move but as soon as you turned car off or battery was disconnected it went back to original problem with a - where the gear number should be and not starting
any ideas please
 
1 - 3 of 3 Posts
Top