Peugeot Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter #1
Hello Everyone,
I have code related to Camshaft position sensor, I looked in the ( owner workshop manual) and it says the it exists only in the 2.0 litre model (see attached screenshot), my question is, if it is available in the 1.6 litre engine, where is it located please ?
 

Attachments

·
Registered
Joined
·
23 Posts
1.6 tu5 engine doesn't use a camshaft position sensor it uses the sparkplugs to assist in a system called phase angle detection to determined the ignition timing. you are using a generic code reader that's why you have got this code check your spark plugs and ignition coil as these are the most likely components that gives timing, misfires,rough idle etc issues
 

·
Registered
Joined
·
23 Posts
Qiuck question did you recently change your sparkplugs? Because these engines are very sensitive to the specific type of spark plugs and many time I have seen issues was due to using incorrect type of these
 

·
Moderator
Joined
·
6,415 Posts
As above could be plugs some plugs appear to work as engine runs fine but you get a the Cam Sensor fault logged as phase detection does not work
 
1 - 7 of 7 Posts
Top