Peugeot Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 20 Results
  1. 508 (2011-18)
    Hi guys, Recent highway event got me worried and I'd appreciate your insight. The car was running for cca 2 hours on a highway at 130-14-kmh speeds on cruise control . After pulling over for a 10min refresh dashboard gave a service engine alert and went into limp mode. Pulled over, restarted...
  2. 307
    Hi all, thought I'd ask here a bit of advice since my mechanic isn't really convincing. I have a 307 2.0 HDi from 2006 with around 270000 on the clock. Last month the car started surging on lower rpms, around 1600-2000 revs. Bit like pumping on gas pedal on-off-on-off. On higher speeds and revs...
  3. Partner
    I have a 2011 Peugeot partner HDi 1.6. I notice a bit of a leak on turbo intake tube. I took that off and found to be some oil on the turbo intake sleeve and some around the turbo but not in the turbo. I then looked under the van and found alot more oil on the underneath of the gear box...
  4. General Discussion
    Hi! I'm writing with an issue where me nor local car service can't figure out the source of the problem and the solution. Problem itself is: During cold weather while driving longer distances turbo intercooler collects condensed water which freezes after the ride if car stays outside and the...
  5. 3008 (2016 & prior)
    Hi guys. New here and relatively new to Peugeot.. I picked up a 2010 3008 1.6HDI two years ago with only 46k on the clock. Just done 70k now and the turbo has blown! I’ve spent the past 7 weeks trying to get this fixed because the garage have a new turbo for me but can’t get hold of the...
  6. 207
    I got this code in my 1.6 thp : P2603 - (Electric) turbo additional coolant pump control fault open circuit. First of all, does this hurt my turbo? Cause the circuit is open not closed. Second, my engine is running arout 70-85*C , is it because of this error or is my thermostat stuck too...
  7. Performance Modifications
    Can I change any parts from the dw10ce to the dw10cd to make it the same hp as the better engine? Basically how do I achieve 180ish bhp out of a dw10ce Thanks in advance
  8. 307
    Hi guys, So I just bought my first Peugeot 307 1.6HDI 2006 and I'm having a issue you guys might be able to help me with. So the main one is there is a serious lack of power. Like I can hardly keep up with traffic. I'm not sure if my turbo is spooling up but I checked it and looks clean and...
  9. 207
    Hi I had a faulty turbo on my 207 1.6 Hdi, so obtained a new Mahle one , i completed an oil change and fitted the turbo. All good.... now 3500 miles later the turbo is whistling and i am having power loss problems. The turbo seems to have oil on the air outlet and on the inlet, the shaft...
  10. 307
    Grateful if anybody can help out please. We have a Peugeot 307 SW 2.0 HDI 135 with the 16V DOHC DW10BTED4 Engine. It ran great a few years ago, like lightning, then there was no turbo boost for a couple of years until we realised that during a clutch and flywheel replacement, the vacuum pipe...
  11. 3008 (2016 & prior)
    Hi all, been a member on hear for years trolling for information this is my first post I believe. I have a Peugeot 3008 BlueHDI150 2010. One of the injectors broke a clamp and filled the intake with crap as I did not notice any problem, must have been running rough and pumping carbon into the...
  12. Partner
    Good morning, I have a 2016 partner with blown turbo seals. The part number is 49373-02003. Looking online I can find loads of turbos that say the are for this vehicle but have a part number starting 49173. My part number is not listed in the oem part number section of the listings. What’s the...
  13. 307
    So on Saturday 17th April my other half and I heard a whistling and clunking noise coming from the engine. We immediately booked it in for a check up through AA, drove it straight home and then didn’t touch it until we took it into the garage Tuesday 20th. Later that day was told a fin had...
  14. General Discussion
    Y’all should help me out I have done all the necessary things to do still showing this
  15. 508 (2011-18)
    Just wanting to know what would be the probable causes for the engine to be in limp mode/prevent revs reaching 1500rpm and above. History of car; when i got it it had either electrical issue/mechissues. Found out it had quite a bit more oil than it should have, drained it refilled with new...
  16. 308 (2007-2014)
    Hi, I have a 308 GT with the EP6CDTX engine. At the moment I have an issue where if I accelerate hard there is a noise like a release of pressure (PSST) mid way through accelerating into a higher gear and then another PSST noise on the gear change. I have not got a dump valve fitted and have a...
  17. RCZ
    On vacation in France right now which is lovely this time of year. On the way here though when we hit the hills i felt i had no power at all i cant hear the turbo spool up no boost nothing. Neither did i get anything on the dashboard... After the car cools down and i drive off again it behaves...
  18. 207
    Hi, I'm new here so I hope I'm posting this in the right place. I've just bought a Peugeot 207 GT, year '08, and the very same day I bought it, it began experiencing turbo issues. I had taken it for a good 'testy' ride, where I definitely pushed it to it's limits and soon after I realised to...
  19. 207
    Hi everyone, I'm not used to posting on forums and have desperately scoured many recently looking for solutions to my problem(s). I figured/hoped that the easiest thing for me to do now is post on a forum and see if anyone can offer me any specific advice. My car is: Peugeot 207 CC Convertible...
  20. 307
    Does anyone know the correct method for replacing the turbo oil feed pipe on Peugeot 307 sw? The original pipe started to leak around the flex, so i bought another one from ebay and replaced it. Now it wasn't an original one from Peugeot, just some store online was selling them. When i...
1-20 of 20 Results
Top