Search Results for ‘petrol’

Hello. I have a Peugeot 206 1.4 petrol from 2001. The car runs without any problems when the engine is cold however when it reaches normal operating temperature (the temperature gauge gets to 90-95C) it starts acting up. Sometimes it starts running rough and if I turn the car on and off it...

Hey guys hope you are all doing good. I have a question i just replaced the high pressure fuel pump. After replacing this i got start problems. It takes like 4-5 seconds before the motor starts running. I checked if i plugged everything back in and put everything in place, it seems to be all...

Okay guys so I’ve been working on this 2013 1.0 petrol (ZMZEngine code) Peugeot 208 now I’ve fixed the cat split issues that plagues these but in the process I was checking the spark efficiency but I was at home due to this being a family members car so I was having to do things the let’s say...

Hi, I've had some trouble with a peugeot 407. After running diagnostics I found a P0335 code error- crankshaft position sensor faulty. I want to test the sensor and the wiring going towards the sensor to find the problem and replace it, but I can't find the sensor. I've seen forums on the 2.0hdi...

I have a Peugeot 207 2008 1.4 Petrol, which went into a garage with an anti pollution fault, it came out not starting. They had locked themselves out of the ECU apparently and had to get a code from Peugeot. Greenflag managed to get it started but now the wipers and lights come on when the key...

Hello all, First post here My girlfriend has a Pug 206 1.4 petrol (8v) which I am trying to work out an overheating issue. What I have tried so far Taken the thermostat out (Its left out at the moment) Cleaned the system with some rad flush, Then took the rad out and ran a hose through it...

hi i have a 407 coupe with the ew12j4s engine and my fuel gauge has gone to the lowest mark and the fuel light has come on also.it was working yesterday but today there is no reading,when you turn the power off theres no reaction. Usually it stays on the correct level until the screen in the...