Peugeot Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. 3008
    Hi all, Recently I got peugeot 3008 made 2011. Car is running fine, no problems there, but when I connected it to diagnostics, there was permanent p0266 code (Injector flow correction cylinder 2 time outside tolerance ), but no check engine light or anything of that sort. When I went to look...
  2. Maintenance
    Ive had to recently replace Injector nr 3 in my car, that went relatively smoothly considering it was my first repair job on a car. Then I tried to program the injector as the acceleration felt a tiny bit off to me. I went into DiagBox and changed the Injector code/serial to the new one and...
  3. 3008 (2016 & prior)
    3008 2011 1.6 hdi 100k. Car packed up on M5 doing 60mph,RAC DTC ScanID- #4 injector fail). After injector(#4) replaced. I have now got a knocking noise, but only when the engine is under torque (Accelerating/slowing), runs lovely when ticking over. This started when I picked car up after...
  4. 5008 (2009-2016)
    Hey guys I replaced the No.3 fuel injector. All good. I took the numbers on the injector. But do I need to programme the injector number into the ecu? Car is running but I don’t know if it is as efficient as it should be. If it does need programming i don’t have a programmer so is there some...
  5. General Discussion
    Can someone please look up the injector bolt torque setting for my 2.0 HDI. My service box is currently downloading. May take some time.
1-5 of 5 Results
Top