Peugeot Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. 307
    Hello, this post is continuation of previous post I made. Basictly, I had this issue where engine starts juddering around 1500-2000rpm with increased diesel knock sometimes even unburned diesel smell. Recently I finally got DPF deleted and EGR blanked and both deactivated in software. But...
  2. General Discussion
    Hi folks. It's a general question so please let it be seen by as many people as possible. Struggling with this for 4 months now. No Codes. Poor acceleration but can achieve 90mph. Does not smoke except 'see below' New MAF/MAP Fuel/Air filter. Vac test done. Smoke test done. Engine...
  3. Expert
    Hi, folks. Same issue as I've always had but exploring all options. Can anyone tell me what my DPF pressure should be? Looking for reasons for stuttering jerking at low revs andpoor acceleration. 2015 Expert 2.0 hdi. Thanks
  4. 508 (2011-18)
    Hi all, All advise appreciated on this issue. I have a 2012 2.0 hdi 163bhp that when fully warmed up will sit with a high idle of around 1300RPM. This reduces to normal idle (800rpm) when the brake pedal is pressed but goes back to 1300rpm when released. It will also drive at this rpm...
  5. 407
    I had to use my brother's car last week, it's a 2007 407sw 2.0HDi. The brake were a bit frighteneing on it, nothing happens for the first half of the pedal going down. then they worked fine. Is that normal? I've got a DS4 2.0HDi and the brakes are like night and day between the two, slightest...
  6. 407
    Hi All, new to the forum but long time lurker. I have a 2.0hdi RHR that had previously developed a huge water leak and has a suspected warped head (pressure in the coolant system, blowing all the coolant out the header tank even on starter only) and have managed to source a low mileage 73k...
  7. 407
    Hello there I have bought my very first car for not a long time ago, after some time it had firstly developed an issue where it would pop the nr8 fuse which is responsible for the starter solenoid. Sometimes the starter would spin without engaging with the flywheel. I have replaced the starter...
1-7 of 7 Results
Top