Peugeot Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results
  1. Boxer
    Morning all chilli one, I have a Boxer 3 2009, was laid up for a while. Turns over a treat but does not fire, I found that the fuse and R10 in engine bay are not operating. If I apply a supply the the fuse it starts. In looking through the wiring diagram R10 appears to come from the ignition...
  2. 308 (2007-2014)
    Hello, I've bought a good taken care of 308 1.6 VTi ym 2009 with 80k milage on it which gives out a spinning noice for max 1 sec at cold startups. Listen to it here: I've replaced the solenoid as I read that could cause the sound but it remains. The sound does not occur again unless I leave...
  3. 207
    Hey, I have had problems with my 2009 Peugeot 207 1.4 8v for a while. Initially the anti-pollution fault light came on, and it would go into limp mode whilst idle, and I have replaced the ECU and the wiring loom which was burnt out following a leak and had caused water ingress into the system...
1-3 of 3 Results
Top