Peugeot Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. 106
    Hello guys, I have a peugeot 106 5 doors and I got a subwoofer that I need to connect to the car battery. I can't find a spot to pass the cable from the driver side to the engine bay. I'm from Portugal so it's left hand drive. If anyone know where to pass the cable please tell me. Thanks
  2. 106
    Recently bought a very rusty pug that only fires on on two cylinders, there is obvious damage to one coil on the coil pack so am going to replace the pack. Any other things I should check? On the topic of rust, is the shell the exact same as a “Zest” trim level? As I am hopefully going to cut...
  3. Performance Modifications
    Hi there, just wondering if anyone could give me some advice/help? I’ve a 2000 Peugeot 106 1.1 (TU1M) HDZ. It’s a single plug ecu, but I’m struggling to find a VTR engine with a loom and ecu that is single plug. If I opted for a three plug VTR engine how would I connect the interior loom? As I...
  4. 106
    Hello again, I made a post on here recently about my 106s unsolved running issues. I was checking for causes of my issue, and I noticed something which has had me a bit miffed. I noticed that the coolant temperature sensor was unplugged, after a bit of rummaging, I found a connector, plugged it...
  5. 106
    Hi all, My 2001 1.1 106 has recently had a head gasket replacement and has been sitting the best part of a year. It usually starts first time but it runs very roughly and will not idle, it just slowly stalls, sometimes immediately. I have replaced the coils and stepper motor but have had no...
1-5 of 5 Results