Cooling fan relay location? 2013 1.6 hdi - Peugeot Forums
Peugeot Forums - Peueot - Citroen Community
Home :: Peugeot Forums :: Rules :: Articles :: About Us :: Partner Vendors :: Advertise


Go Back   Peugeot Forums > Peugeot Models > Vans > Partner
PeugeotForums.com is the premier Peugeot All Forum on the internet. Registered Users do not see the above ads.
Reply
 
LinkBack Thread Tools Display Modes
Old 07-06-18, 09:34 PM   #1
Junior Member
 
Join Date: Jun 2018
Location: The North
Posts: 1
Default Cooling fan relay location? 2013 1.6 hdi

I am suffering a mystery "major engine fault" Causing limp mode. Only thing found with backstreet diagnostics was low speed fan not working and Oil pressure/level sensor which may be a software glitch.
So i put a new fuel filter in. Nope.
Whipped the front end off fitted a new fan.. ok till i stop at a junction and limp mode.? Any help greatly appreciated.
TaxiStuff is offline   Reply With Quote Quick reply to this message
Sponsored Links
Advertisement
 
Old 08-06-18, 06:48 AM   #2
Senior Member
 
border_all's Avatar
 
Join Date: May 2013
Location: Teesside
Posts: 1,860
Default

Quote:
Originally Posted by TaxiStuff View Post
I am suffering a mystery "major engine fault" Causing limp mode. Only thing found with backstreet diagnostics was low speed fan not working and Oil pressure/level sensor which may be a software glitch.
So i put a new fuel filter in. Nope.
Whipped the front end off fitted a new fan.. ok till i stop at a junction and limp mode.? Any help greatly appreciated.
You dont mention a code but recently Iíve been looking at a Peugeot service bulletin. Not saying this is your issue but might be worth a read

P0493 - OBD-II Trouble Code | BestRide.com
__________________

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
border_all is offline   Reply With Quote Quick reply to this message
Old 08-06-18, 07:35 PM   #3
Senior Member
 
Join Date: Sep 2016
Location: New Zealand
Posts: 1,134
Default

If the system is getting ANY feedback from the oil sensor that oil pressure is an issue, it will trigger a MAJOR fault and could even shut down the motor.
You need to sort out the 'issue' you are having with the oil sensor. Maybe it is not a 'software glitch' and your motor is about to nuke itself...???
WillNZ is offline   Reply With Quote Quick reply to this message
 
Old 01-07-18, 09:55 PM   #4
Junior Member
 
Scootyman's Avatar
 
Join Date: Jun 2018
Posts: 2
Default

I have recently had similar problems with my Partner Tepee. I had two fault codes which related to both low speed fan and high speed fan not working. It stopped my air con working and also stopped my DPF regeneration but I also went into limp mode with the words engine fault appearing on screen.
How I fixed it was by replacing the cooling fan control unit which is located right next to the cooling fan on the fan housing.
After I replaced this I still got the engine fault display on dash and limp mode so I unplugged the cooling fan and fed 12 volts to it from a 30 amp battery I had in the garage. It span up ok so I suspected it was power not getting to the fan itself. I then lifted the fuse board under the bonnet and on the front underneath there is some maxi fuses. One of the 50 amp fuses had indeed blown so I replaced it and yep, my fan burst into life and the engine fault message is now gone and car regens the DPF as it should.
I’m not saying this is your fault but maybe you could look at the fan control unit first. Put a meter over the resistor and see the reading. My new part read .8 ohms and the old one didn’t give a reading so obviously it was knackered. You could then check the maxi fuses and see if any have blown.

Worth a try as the garage I took mine to for a diagnoses said with low speed fan fault, more often than not that code related to the fan control unit and sometimes it takes the maxi fuse with it when it malfunctions.
Hope that helps
Scootyman is offline   Reply With Quote Quick reply to this message
Sponsored Links
Advertisement
 
Reply

Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the Peugeot Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in


Thread Tools
Display Modes

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT. The time now is 01:11 PM.



Powered by vBulletin® Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.