Peugeot Forums banner

Diagbox issue

4K views 21 replies 5 participants last post by  Fordiemufc 
#1 ·
Ok so after my heater decided to stop working yesterday I went into diagbox for the second time in a few weeks and when it came to the vin bit I had to put it in manually rather than the software detecting it its self like it did the first time I used it.

How ever it now will not read anything at all just no dialogue next to everything.
I can here all the components clicking when it does a global scan but just get the no dialogue so unable source issue out.
Anyone else had this and know what the cause is?
 
#6 ·
Try deleting the interface from device manager and let it reinstall in case it a corrupt driver. Also check firmware version with interface checker

Sent from my SM-T813 using Tapatalk
 
#7 ·
I agree sounds like a driver issue i get this from time to time i have found that it must be plugged into a specific usb port when this happens it will then be happy no idea why as usb in theory is all connected together inside laptop!
 
#9 ·
No joy at all..refuses to connect to the car.
Will not auto detect and manually putting the vin in fails to.
I even checked and changed fuse for the ECU.

Think I am done with this car not being able to sort the simplest tasks with this car is starting to frustrate me.
 
#10 ·
Your issue is with the adapter not the car

As for your heater issue its most likely wiring under the dash so getting comms wont help in that respect some things dont need a computer to fix get under the dash glovebox side and find the blower give the wires a wiggle if the blower then comes on its dodgy wiring very common on peugeots.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top