Front bumper grille replacement - Peugeot Forums
Peugeot Forums - Peueot - Citroen Community
Home :: Peugeot Forums :: Rules :: Articles :: About Us :: Partner Vendors :: Advertise


Go Back   Peugeot Forums > Peugeot Models > 308 > 308 (2007-2014)
PeugeotForums.com is the premier Peugeot All Forum on the internet. Registered Users do not see the above ads.
Reply
 
LinkBack Thread Tools Display Modes
Old 05-03-13, 04:41 PM   #1
Inactive User
 
Join Date: Mar 2013
Posts: 2
Default Front bumper grille replacement

Hi all, just bought a 308 2011 e-hdi. On way home hit a pheasant. Grille is broken and plastic snapped off it everwhere.

1. Where can I get a replacement grille?
2. I assume I have to remove the bumper, any advice here?
3. Is the grille different on a late 61 than an early one?
4. Part number?

Thanks for any help you can give!
pug308logic is offline   Reply With Quote Quick reply to this message
Sponsored Links
Advertisement
 
Old 05-03-13, 06:38 PM   #2
Member
 
paz45's Avatar
 
Join Date: Nov 2012
Location: North West
Posts: 91
Default grill

theres a grill on ebay

PEUGEOT 308 2008 2011 Front Bumper Grille Silver | eBay

would need your vin number to get part number from Peugeot service box
paz45 is offline   Reply With Quote Quick reply to this message
Old 05-03-13, 06:43 PM   #3
Inactive User
 
Join Date: Mar 2013
Posts: 2
Default

Thanks for that. That looks like it only goes up to the old '11. I think we have the newer one, but can't be sure. It's also silver, the original one is black.

Not sure what you mean about the 'Puggy service box'?

Thanks.
pug308logic is offline   Reply With Quote Quick reply to this message
 
Old 05-03-13, 06:53 PM   #4
Member
 
paz45's Avatar
 
Join Date: Nov 2012
Location: North West
Posts: 91
Default

Service Box

Independent Operators - Technical Documentation

you input your vin number and it will tell you exact part numbers
for your car
Attached Thumbnails
capture.jpg  

Last edited by paz45; 05-03-13 at 07:05 PM.
paz45 is offline   Reply With Quote Quick reply to this message
Old 08-03-14, 06:34 PM   #5
Inactive User
 
Join Date: Feb 2014
Location: Buckinghamshire
Posts: 3
Default

Quote:
Originally Posted by pug308logic View Post
Hi all, just bought a 308 2011 e-hdi. On way home hit a pheasant. Grille is broken and plastic snapped off it everwhere.

1. Where can I get a replacement grille?
2. I assume I have to remove the bumper, any advice here?
3. Is the grille different on a late 61 than an early one?
4. Part number?

Thanks for any help you can give!

I have just finished replacing the broken grille on my wifes Peugeot 308 (09 reg) wiuth the help of a YouTube video in Russian .
not that I could understand what they were saying but at least you can follow what they are doing.
If attempting this, allow a good three hours which is what it took me as there are many bolts to undo and a knack of pushing and pulling fragile plastic lugs. Take your time.
Removal can be done without putting car on ramps as you will need to put the wheels on full lock to get at the wheel-arch liners.
Firstly, undo the various screws on the plastic tray underneath the engine which connect to the front bumper skirt. There are three main bolts with washers which are located half way back, one central and one each side.
Secondly, put the steering on full lock to give you access to the wheel-arch liner for each front wheel. Pull the wheel-arch liner back to reveal a 10mm bolt where the bumper meets the wing of the car. You will need a ratchet with a swivel knuckle and 10mm socket to get onto the bolt head. Undo the bolt and repeat on the other side.
Lift the bonnet and at the front edge you will see four black flat circles. Using a small flat blade screwdriver, lever up the centre and you can then lift up with your finger which releases the retaining plastic bolts.
Looking at the top of the panted front bumper where it attached to the front of the engine compartment, you will see several small slots along the width of the plastic which you can place a small flat bladed screwdriver into and push down gently whilst pulling the front panel forwards in a rocking motion to release the plastic lugs. The whole bumper assembly should then start disconnecting from the car. It is helpful to have a second person to gentle prise away the wheel-arch sections from the car body. The whole front bumper section should then fall away but be careful as the wiring for the front fog lights will still be attached. Take hold of the lamp holders and turn through 90 degrees to remove the bayonet fittings. Pull the bumper assembly clear of the car and place on a fabric cloth/mat to avoid scratching the paintwork.
Re-fitting is a reverse of the above.
Colin B is offline   Reply With Quote Quick reply to this message
Sponsored Links
Advertisement
 
Reply

Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the Peugeot Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in


Thread Tools
Display Modes

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT. The time now is 04:29 AM.



Powered by vBulletin® Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.