Peugeot 307 Automatic Gear Stuck in Gear 3 - Peugeot Forums
Peugeot Forums - Peueot - Citroen Community
Home :: Peugeot Forums :: Rules :: Articles :: About Us :: Partner Vendors :: Advertise


Go Back   Peugeot Forums > Peugeot Models > 307
PeugeotForums.com is the premier Peugeot All Forum on the internet. Registered Users do not see the above ads.
Like Tree3Likes

Reply
 
LinkBack Thread Tools Display Modes
Old 13-09-17, 08:13 AM   #1
Junior Member
 
Join Date: Nov 2016
Posts: 10
Question Peugeot 307 Automatic Gear Stuck in Gear 3

Hello Peugeot Enthusiasts,

My car is Peugeot 307 1.6 16V 110PS Petrol Engine with Automatic Transmission (AL4) that has done only 55640 miles (89544 kilometers) on it.

I got "Gear Box Faulty" on Dashboard and noticed sluggish movement. Took it to a garage and we found there was no transmission oil (ATF) because driveshaft seal was leaking.

We changed seal, flushed ATF (because it was black after top up) and car would only enter only enter gear 3 in manual mode now. I would have to change to gear 2 for car to move at all, then it would not move when you change to 3 but when you slow down, it will change from 2 to 1 and finally to D even though you are in manual mode.

On automatic mode, D would not move until revved hard, then gear engages 3 in manual mode by itself and would have to manually change to 2 and the above process is repeated.

We scan and results are as follows:

U1313: Incorrect rear R hand wheel speed transmittal by ABS
U1313: Incorrect rear L hand wheel speed transmittal by ABS
0721: Vehicle Speed Information
0717: Gearbox Input Speed Signal

I should really appreciate your experience and expertise as I love this car!

Many thanks,
Topy
Peugeout307 is offline   Reply With Quote Quick reply to this message
Sponsored Links
Advertisement
 
Old 13-09-17, 02:14 PM   #2
Senior Member
 
Join Date: Oct 2012
Location: falkirk
Posts: 14,049
Default

If the gearbox lost all its oil its most likely toast replacing the oil wont fix all the cooked clutches !
__________________
assume nothing check everything twice !!
reliable406 is offline   Reply With Quote Quick reply to this message
Old 13-09-17, 03:32 PM   #3
Junior Member
 
Join Date: Nov 2016
Posts: 10
Default

Thanks for the advice.


Updated information:

The garage did not check ATF oil level properly. They checked while engine was not running and topped with Dextron III instead of Mobil LT71141.

Error after scanning are:

U1313: Incorrect rear Right and Left hand wheel speed transmitted by ABS

Gear is stacked in 3 in manual mode

Any further tips, advise or experience?
Peugeout307 is offline   Reply With Quote Quick reply to this message
 
Old 13-09-17, 03:45 PM   #4
Senior Member
 
Join Date: Oct 2012
Location: falkirk
Posts: 14,049
Default

dexron 3 is fine the other stuff is just long life oil i always use dexron that does not change what i said the clutches will be burnt out.

ABS errors are a separate issue.
Peugeout307 likes this.
__________________
assume nothing check everything twice !!
reliable406 is offline   Reply With Quote Quick reply to this message
Old 13-09-17, 04:31 PM   #5
Junior Member
 
Join Date: Nov 2016
Posts: 10
Post Re: Peugeot 307 al4 auto transmission issue

Quote:
Originally Posted by reliable406 View Post
dexron 3 is fine the other stuff is just long life oil i always use dexron that does not change what i said the clutches will be burnt out.

ABS errors are a separate issue.
According to: Peugeot 307 AL4 and ABS crazy on faults and car speed. 655Km/h, ABS could be the issue.

What is recommendation on clutch burn out?
Peugeout307 is offline   Reply With Quote Quick reply to this message
Old 13-09-17, 04:37 PM   #6
Senior Member
 
Join Date: Oct 2012
Location: falkirk
Posts: 14,049
Default

If the clutches are burnt its a new box or recon

If it was a FRONT abs sensor then yes it would affect the box but it does not use the rear sensor readings your rear sensors just need the rust removed from under them common issue on 307/308
__________________
assume nothing check everything twice !!
reliable406 is offline   Reply With Quote Quick reply to this message
Old 13-09-17, 07:49 PM   #7
Junior Member
 
Join Date: Nov 2016
Posts: 10
Post

How do we know whether or not the clutches are burnt? Are there specific fault codes for that as the diag has not produced those faults.

Also, the link I shared also pointed rear ABS as culprit for gear misbehaving?

What further thought can you help with? Or do you require further information?

Many thanks for the assistance.
Peugeout307 is offline   Reply With Quote Quick reply to this message
Old 13-09-17, 07:59 PM   #8
Senior Member
 
Join Date: Oct 2012
Location: falkirk
Posts: 14,049
Default

Best thing to do is sort the rear sensors the gaps will be too big then see if it fixes your issues personally i doubt it having seen these boxes in bits i know how bad they can get if run low in oil

You dont get fault codes for mechanical issues only electrical issues give fault codes.
Peugeout307 likes this.
__________________
assume nothing check everything twice !!
reliable406 is offline   Reply With Quote Quick reply to this message
Old 13-09-17, 08:08 PM   #9
Junior Member
 
Join Date: Nov 2016
Posts: 10
Post Peugeot 307: Gear Stucked in 3

Many thanks.

I shall give the ABS a cleaning so we see what happens!

I shall report back before looking at transmission itself (Would have gone with al4 gear bad if garage had checked properly)
Peugeout307 is offline   Reply With Quote Quick reply to this message
Old 05-10-17, 02:00 PM   #10
Junior Member
 
Join Date: Nov 2016
Posts: 10
Default Experience changing 307 Automatic GearBox (AL4)

Hello:

I changed the gearbox (AL4) yesterday and car moved fine- gears changed when gear is in D (Drive).

My new concerns are:

1. These seems to be a forced engagement of gear typified by a noise like two things smashing together occasionally when I stop at traffic light or stop due to traffic. I has happened about 4 times since we installed the al4 automatic gear yesterday.

2. Rear ABS fault is still showing on dashbaord

3. In stationary mode - manual change only change 1, 2 3 but would not change to gear 4. Gear installer said this is how al4 gear works. That it will only change to 4 while in motion - is this true? Previous gear shows 1-4 while stationary and you engage gears in manual mode.

Any experience, tips, advice would be appreciated as it could save me money before I certified job is completed and make final payments.

Thanks
Peugeout307 is offline   Reply With Quote Quick reply to this message
Sponsored Links
Advertisement
 
Reply

Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the Peugeot Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in


Thread Tools
Display Modes

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT. The time now is 05:15 AM.



Powered by vBulletin® Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.