Extreme engine judder - Peugeot Forums
Peugeot Forums - Peueot - Citroen Community
Home :: Peugeot Forums :: Rules :: Articles :: About Us :: Partner Vendors :: Advertise


Go Back   Peugeot Forums > Peugeot Models > 207
PeugeotForums.com is the premier Peugeot All Forum on the internet. Registered Users do not see the above ads.
Like Tree3Likes
  • 1 Post By jimmymarsbar
  • 1 Post By jimmymarsbar
  • 1 Post By scottez

Reply
 
LinkBack Thread Tools Display Modes
Old 07-06-17, 06:05 PM   #1
Junior Member
 
Join Date: Jun 2017
Posts: 3
Default Extreme engine judder

PLEASE HELP
I am experiencing extreme engine judder.
I recently bought a 2009 207 sw s 1.6 hdi 90.
It is the single mass flywheel version.
It's only covered 39000 miles.
When depressing the clutch on take off in first gear, also in reverse the engine is juddering to the point that you can hear it violently moving back and forwards.
You can also here and feel this, all be it no where near as bad when gearing down from 4 th to 3rd ECT.
I've fitted a new 3 piece LUK clutch kit and had the bottom 2 gear box mount bushings replaced.
I've taken it to a gear box specialist who has said it's not the box.
Nobody can tell me for sure what it is.
I've had all the engin mounts checked and also been told it's not the bottom pulley.
Also been told by another garage that it's either the flywheel or gearbox or both.
Don't want to chuck loads of money at it fixing things and still have the same problem.
Strut top mounts and wishbone are also fine.
Only happens when depressing the clutch.
The engine runs clean and smooth when not depressing the clutch.

Sent from my SM-G935F using Tapatalk
scottez is offline   Reply With Quote Quick reply to this message
Sponsored Links
Advertisement
 
Old 07-06-17, 07:15 PM   #2
Senior Member
 
Join Date: Feb 2016
Location: Thackley, West Yorks
Posts: 1,825
Default

Had a very similar issue, had a 307 2.0hdi with a single body flywheel conversion.

Took the car in for a clutch change, sourced a valeo clutch kit, had it fitted, and the car juddered as the clutch bit in first and reverse.

Took it back to the garage, they couldn't find the reason why it juddered. They said it's likely to be the driveshaft, perhaps the splines were worn and were jumping/camming out.

It got slightly better over time, but never went away.

My personal thoughts were that the flywheel was warped or loose. Maybe it was misaligned. Unfortunately I never got to the bottom of it.
scottez likes this.
jimmymarsbar is offline   Reply With Quote Quick reply to this message
Old 07-06-17, 07:45 PM   #3
Junior Member
 
Join Date: Jun 2017
Posts: 3
Default

Quote:
Originally Posted by jimmymarsbar View Post
Had a very similar issue, had a 307 2.0hdi with a single body flywheel conversion.

Took the car in for a clutch change, sourced a valeo clutch kit, had it fitted, and the car juddered as the clutch bit in first and reverse.

Took it back to the garage, they couldn't find the reason why it juddered. They said it's likely to be the driveshaft, perhaps the splines were worn and were jumping/camming out.

It got slightly better over time, but never went away.

My personal thoughts were that the flywheel was warped or loose. Maybe it was misaligned. Unfortunately I never got to the bottom of it.
Thanks for the reply.
I am thinking it's the flywheel.
It had judder before I got the clutch done but became far worse after the new clutch was fitted.
Probably due to biting more.

Sent from my SM-G935F using Tapatalk
scottez is offline   Reply With Quote Quick reply to this message
 
Old 07-06-17, 09:33 PM   #4
Senior Member
 
Join Date: Feb 2016
Location: Thackley, West Yorks
Posts: 1,825
Default

The garage did say that the clutch might need to bed in to the flywheel. But that wasn't practical as up-hill starts and moving off were dangerous as I needed to give the engine over 2000 revs just to get it moving.
scottez likes this.
jimmymarsbar is offline   Reply With Quote Quick reply to this message
Old 14-06-17, 04:11 PM   #5
Junior Member
 
Join Date: Jun 2017
Posts: 3
Default

Problem solved.
Flywheel had an imbalance.
Totally fucked the new clutch I'd
Put in 500 miles ago though.
New clutch and skim the existing flywheel for anybody with the same problem.


Sent from my SM-G935F using Tapatalk
Gibbo likes this.
scottez is offline   Reply With Quote Quick reply to this message
Sponsored Links
Advertisement
 
Reply

Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the Peugeot Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in


Thread Tools
Display Modes

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT. The time now is 02:04 AM.



Powered by vBulletin® Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.