expert 51 plate keeps cutting out......help

eddy1431trp · 05-31-2011, 07:41 PM

hi. expert van 51 plate broke down the other week RAC man said fuel pump dead . replaced fuel pump and fuel pump relay now runs ok but when throttle depressed cuts out . once cut out will only re start once ignition switched off and on hearing a click presumably on fuel pump or that area will then restart .....run ok before breakdown apart from on heavy accelaration would cut out ......

any ideas please ..HELP

kelvinauto · 06-28-2011, 10:47 PM

I have the same problem ..thought it was fuel starvation so changed the filter.. nope ... its when I go to boot it up a hill or to overtake .. it cuts out ... turn the ignition off count to ten turn it on let the primer pump stop and up it fires again .... what can it be ????

eddy1431trp · 07-03-2011, 09:03 PM

gave up and sent it to garage in the end been there two weeks now, firstly high pressure sensor on front pump pin inside had broken , so replaced part ran fine for 10 mile ish then went again plugged in computer and said air flow metre so when af meter unplugged it runs fine just waiting on further news from garage

05-31-2011, 07:41 PM	#1
eddy1431trp Junior Member Join Date: May 2011 Posts: 2	expert 51 plate keeps cutting out......help hi. expert van 51 plate broke down the other week RAC man said fuel pump dead . replaced fuel pump and fuel pump relay now runs ok but when throttle depressed cuts out . once cut out will only re start once ignition switched off and on hearing a click presumably on fuel pump or that area will then restart .....run ok before breakdown apart from on heavy accelaration would cut out ...... any ideas please ..HELP Share Share this post on Digg Del.icio.us Technorati Twitter

06-28-2011, 10:47 PM	#2
kelvinauto Junior Member Join Date: Jun 2011 Posts: 2	Peugeot expert euro bus I have the same problem ..thought it was fuel starvation so changed the filter.. nope ... its when I go to boot it up a hill or to overtake .. it cuts out ... turn the ignition off count to ten turn it on let the primer pump stop and up it fires again .... what can it be ???? Share Share this post on Digg Del.icio.us Technorati Twitter

07-03-2011, 09:03 PM	#3
eddy1431trp Junior Member Join Date: May 2011 Posts: 2	gave up and sent it to garage in the end been there two weeks now, firstly high pressure sensor on front pump pin inside had broken , so replaced part ran fine for 10 mile ish then went again plugged in computer and said air flow metre so when af meter unplugged it runs fine just waiting on further news from garage Share Share this post on Digg Del.icio.us Technorati Twitter

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
PeugeotForums.com Advertisement