307 PP Diag output.

[RichTea]

I ran PP on my car whilst i was reprogramming the key looks like there are a "few" issues...

Any one have suggestions on the faults i saw?

BSI F017 Absence of communication with the ECU/diesel fuel additive pump : not characterised. local. permanent Local
BSI F.98A Engine fuse box: Front right side light fault. not characterised . local . Permanent Local
HDI_SED803 P1351 Permanent fault. pre/post heating relay circuit relay not controlled and spark plugs supplied Permanent Local
ECU fault code P1351
Engine speed 0 Rpm
Measured injected flow 18.50 Mg/impulse
Coolant temperature 21 Deg, C
Vehicle speed 0 K.p.h.
Batter/ voltage 11.75 Volt(s)
Engine status Engine off
Time elapsed since ignition positive 6 Seconds
AccelerAr pedal position, wire 1 0 %
Accelerator pedal position, wire 2 0 %
Main brake Inactive
AAS FBC9 Interior rear right sensor fault . not characterised. local . Permanent Local