307 air pipe - maf sensor to turbo

[bazzoh]

hi!
as above to fit a 53 reg 1.4 hdi - this is the pipe with the breather attached - my seems to be leaking!
any help would be great!
many thanks
baz

[sterion75]

What is your question, are you needing a new pipe? is yours not repairable? Is it a new grommet needed at the turbo end?

[bazzoh]

Hello! Yeah I'm lookin for a replacement ideally. There's oil leaking from either where the breather pipe enters the air pipe or it's from under the jubilee clip at the turbo end - unless anyones got a quick fix?
Thanks!

[sterion75]

at the turbo end is a rubber grommet orange on a 407 £10 each from the stealers. on the breather is an O ring,they can be bought in varying sizes from motor factors so take a pattern. if buying from peugeot they may not come separate from the pipe but worth looking anyway. should cure your probs, good luck with it.

[bazzoh]

Thanks for that - fairly sure I've not seen an o ring between the breather and air pipe so I'm guessing that could be the problem! Many thanks!

[sterion75]

If you fit a grommet clean the stub of the turbo of all traces of oil, also in the air pipe.Push the grommet into the air pipe and fit to the turbo, don't over tighten or you can split the grommet, did it myself. It will stay in place with minimal tightening and the more you tighten the grommet will squash and force itself off the turbo splitting itself. Dont forget the o ring or you will have to fit the pipe all over again.

[sterion75]

the o ring cant be seen until you pull the pipe off. Didnt read properly that's for 407 but should be same principal for yours

[bazzoh]

ok - thanks! ill have a look tomorrow and see what i find!