![]() |
| |
|
|||||||
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
#1 |
|
Junior Member
Join Date: Dec 2011
Posts: 5
|
Hello and merry xmas everybody
My horn on my 2004 peugeot 307 1.4 envy Only works when you press the middle of the steering wheel very hard, I would be very grateful for any help on what to check on this Fault please
|
|
|
|
| Sponsored Links | |||
Advertisement | |||
|
|
#2 |
|
Super Moderator
|
there is a fix and i believe the guide is under the how to section on the forum
__________________
John H !!!READ THIS FULLY BEFORE POSTING NEW THREADS/POSTS!!! Peugot Planet Map Used to Own: Peugeot 307 1.6 Rapier, 4 cyl, 16V, Go-Go Juice, 5 door, 2001, blue What Happened to My 307 Now currently Owns: Ford Focus 1.8 TDCI, Climate Pack, 5 door, 2006, silver |
|
|
|
|
|
#3 |
|
Senior Member
Join Date: Nov 2011
Posts: 128
|
|
|
|
|
|
|
#4 |
|
Junior Member
Join Date: Dec 2011
Posts: 13
|
Had same problem on my 02 307, disconnect battery and leave for half hour (so airbag doesnt blow up in your face!) behind steering wheel you will feel a little slot on each side, push a screwdriver in each side inwards and the front cover (the horn press on the wheel) will come off, inside is a v-shaped brass connector on a wire carefully pull this out and with a needle file clean around the edges of the hole and the v-shaped connector, put some vaseline around the edges you have filed, add a little tension to the connector and push back in and put everything back together and your horn will work! mine did, there is a video and step by step instructions somewhere on the web, apparently it is another common fault on 307's! good luck!.
|
|
|
|
|
|
#5 |
|
Senior Member
Join Date: Jan 2010
Location: Southern Ireland
Posts: 2,333
|
The are three little brass studs on the steering wheel itself. They get burned from the current that operates the horn running through them.
Run a bit of sandpaper over each of them and it should work again. You will need to remove the three t20 screws that holds on the black plastic bracket. When the bracket comes off it will come off with 3 springs. Don't worry they will go back on no problem. Basically you'll see what needs to be done when you remove the airbag and then the bracket.
__________________
Peugeot Master Tech/Citroen Tech |
|
|
|
| Sponsored Links | |
Advertisement | |
![]() |
| Thread Tools | |
| Display Modes | |
|
|