Airbag fault x 2

garethned · 06-09-2011, 11:45 AM

When I start my 2005 307 HDI 2.0L 90HP I get 'airbag fault' on the screen with a beep. It does this twice before going back to normal.

Any ideas?

The car was Cat C repaired prior to me having it and was wondering if I need to have the airbag module reset, as it is still holding crash data? As far as I can see all airbags are ok and none were deployed (bumper damage only)

Cheers

Gareth

307pugpete · 06-09-2011, 12:33 PM

Sounds like the module needs resetting. This guy is great , send him the module and its back in 2 days restored to factory settings , plug and play no messing:

PEUGEOT 307 AIRBAG MODULE ECU (RESET) | eBay UK

garethned · 06-09-2011, 04:14 PM

Nice one. Any ideas where the module is? I heard its near the gear stick?

Are there any 'do's & don't' about removing/putting back?

Cheers

307pugpete · 06-09-2011, 04:51 PM

Its under the plastic consol behind the gearstick. Just make sure the ignition isnt on and hasnt been on in the last 5 minutes. People say disconnect battery etc etc but i never have and iv done more than a few

paulpeugeot · 08-04-2011, 05:43 PM

I have just purchased a 307 ( 2004 plate ) and all was ok on the way home and then i got airbag fault displayed on dash and air bag light fails to go out. My neighbour who is a mechanic got the fault code P1808 permanent fault side module trigger right open circuit

any ideas

06-09-2011, 11:45 AM	#1
garethned Junior Member Join Date: May 2011 Posts: 22	Airbag fault x 2 When I start my 2005 307 HDI 2.0L 90HP I get 'airbag fault' on the screen with a beep. It does this twice before going back to normal. Any ideas? The car was Cat C repaired prior to me having it and was wondering if I need to have the airbag module reset, as it is still holding crash data? As far as I can see all airbags are ok and none were deployed (bumper damage only) Cheers Gareth Share Share this post on Digg Del.icio.us Technorati Twitter

06-09-2011, 12:33 PM	#2
307pugpete Senior Member Join Date: Feb 2011 Location: Rotherham -S Yorks Posts: 375	Sounds like the module needs resetting. This guy is great , send him the module and its back in 2 days restored to factory settings , plug and play no messing: PEUGEOT 307 AIRBAG MODULE ECU (RESET) \| eBay UK Share Share this post on Digg Del.icio.us Technorati Twitter __________________ PEUGEOT PLANET/CITROEN LEXIA/RENAULT CLIP DIAG

06-09-2011, 04:14 PM	#3
garethned Junior Member Join Date: May 2011 Posts: 22	Nice one. Any ideas where the module is? I heard its near the gear stick? Are there any 'do's & don't' about removing/putting back? Cheers Share Share this post on Digg Del.icio.us Technorati Twitter

06-09-2011, 04:51 PM	#4
307pugpete Senior Member Join Date: Feb 2011 Location: Rotherham -S Yorks Posts: 375	Its under the plastic consol behind the gearstick. Just make sure the ignition isnt on and hasnt been on in the last 5 minutes. People say disconnect battery etc etc but i never have and iv done more than a few Share Share this post on Digg Del.icio.us Technorati Twitter __________________ PEUGEOT PLANET/CITROEN LEXIA/RENAULT CLIP DIAG

08-04-2011, 05:43 PM	#5
paulpeugeot Junior Member Join Date: Aug 2011 Posts: 28	I have just purchased a 307 ( 2004 plate ) and all was ok on the way home and then i got airbag fault displayed on dash and air bag light fails to go out. My neighbour who is a mechanic got the fault code P1808 permanent fault side module trigger right open circuit any ideas Share Share this post on Digg Del.icio.us Technorati Twitter

Remove Advertisements Sponsored Links
PeugeotForums.com Advertisement

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode