ABS fault

[chrisw]

Morning, can any one please help!!!!

Ive recently had new brakes and discs fitted to my 307 1.4hdi, as well as two new ABS censers but the following fault wont go away.

Fault code ; C1381

Intermittent Fault ; ABS/ASR recirculation pump, electrical fault.

Status & Location ; temparry local

Please help as my MOT is due and ive been told this fault will be a fail ????

[CAB]

I read the codes for the above mentioned 307.

This is what planet came back with.

Screen dump attached!!

I know the rear sensor is likely to be gap,crap or knackered aren't sure which ones have been replaced. But why would it be mentioned twice??

Would clutch fault be switch on pedal?

Aren't sure on the abs pump.

Never had much to do with 307 so far.

[bettyswollocks]

Forget clutch fault seen this before not important ,

looks like a sensor or wiring fault ,

have you cleared all to see what comes back?

[CAB]

No didn't clear them, but will try that.

But I think the mechanic who looked at it couldn't find fault or cure it so car was going to dealers.

Thought unless there was a fault abs light would go out but codes stored on ecu.

Will try clearing and go from there!!

Chris, Which sensors did your mech replace? when you back at work? and is it before car goes to dealers?

[jmkent]

As an aside, where do you get that summary fault box in PP - I've only got faults one at a time in each ECU after doing global test, and then going into each one.

[CAB]

Originally Posted by jmkent

As an aside, where do you get that summary fault box in PP - I've only got faults one at a time in each ECU after doing global test, and then going into each one.

If I remember correctly it's f11, icons are bottom of screen.


After global scan think you press f11 it will scan ecu's with faults then f11 again and you get summary.

Cris.