206 1.4 hdi

[Grant4080]

hi all

i wrote about a month ago about my 1.4 HDI 206 was not to well problem was the cam shaft sensor.

no i have a new problem after fitting the last part above i done 50 mile then stopped the van and have not been able to start it again the engine will turn over but will not fire. i got a local garage to put there dignostics machine on it and it came up no faults has any one got any idea why it will not fire.

all the best

Grant

[Grant4080]

i have managed to start the van, i used the hand primer pump but it has gone soft again starts no problem after 2-3 hours but needs reprimed again i am going to go out on a limb here and say the problem is the hand primer none return valve if people agrree with this please comment so i no what part to get

all the best Grant

[jmkent]

Could be, or could just be a blockage somewhere in the diesel line?

[bettyswollocks]

Check the fuel lines below air filter , they rub of air filter housing and cause air leaks .