Parrot MKI9200 Install

[daffyduck]

I am going to put a parrot mki9200 in my 307 this week. Doesnt seem at all difficult as its just iso adaptors on the wiring loom and the peugeot 307 stereo has just iso connectors.

Im just wondering if the way the peugeot is wired, what with the mfd display wires, will it work...

[teerak2uk]

The display won't be affected by the standard iso plugs as these only carry power on one and speakers on the other

[daffyduck]

Its the ignition control that may cause problems. The 307 doesnt have a normal ignition control, you find that out when you change your standard headunit to a aftermarket. You have to swap a wire over, otherwise the headunit will start switching on when you open the doors, some thing to do with the bsi.

Anywho, just want to make sure it will work ok, suppose there only one way to find out....

[teerak2uk]

Originally Posted by daffyduck

Its the ignition control that may cause problems. The 307 doesnt have a normal ignition control, you find that out when you change your standard headunit to a aftermarket. You have to swap a wire over, otherwise the headunit will start switching on when you open the doors, some thing to do with the bsi.

Anywho, just want to make sure it will work ok, suppose there only one way to find out....

If in doubt check for ign feed at cig socket and if its ign controlled wire your ign wire to it

[daffyduck]

All sorted, easily installed, just had to run permanent feed to fuse box and switched to cigarette lighter.

Havent got it permanently installed, not decided on where to put the blue box, any ideas....

[teerak2uk]

Permanent feed would be at radio

[daffyduck]

No, you misunderstood, I mean, where to mount the actual box of the parrot handsfree....

[teerak2uk]

Blue box behind heater controls or glove box

[daffyduck]

Was thinking those two exact places but behind heater Im scared box will over heat and since I have the parrot lcd screen mounted at driver side air vent then I doubt cable will reach to glovebox...

[teerak2uk]

Trust me if there is room behind heater switch panel it will be fine there just be careful when routing cables as some dash brackets have sharp edges