![]() |
| |
|
|||||||
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
#1 |
|
Junior Member
Join Date: Jul 2011
Posts: 3
|
hello there,
im Pearse an expierienced maintenance electrisian from Tyrone N.ireland my dads 406 hdi 90bhp was driving down road at 40mph when Car stopped dead and speedo and rev counter and all of clocks and instrument panel froze e.g rev counter stayed at 2500rpm and speedo 41mph when stopped dead car will turn over but wont start or put instrucment panel back to normal or light it up or light climate control unit up either i went round every fuse tested every one-all ok went round every relay,tested every coil and n/o and n/c-all ok checked BSI for burning on board-ok ecu plugs-non burnt all ok check all obvious earths-ok i found 2 small burnt bad connections in a connector block under drivers carpet and repaired them as necessary but still no change spent a day and eventually got dash clocks and speedo back to normal(lighting up and working etc but only by back feeding a 12v supply back up a illumination/ignition wire of aftermarket cd player that must be spurred round that circut car will turn over but still not start or even try to start was put on diagnostic machine but no faults car is getting diesel etc but i dont think ecu is letting injectors open close accordingly at all would this possibly be a BSI or ECU fault? what relay or what item sends power to clocks/instrucment panel when car is switched on? i have few electrical drawings but there for LHD car in france so not great and links or places to get correct electrical drawings for UK 2002 peugeot 406 HDI diesel 90? any help appriciated i believe car is siemens electrical system and bosch braking system thanks |
|
|
|
| Sponsored Links | |||
Advertisement | |||
|
|
#2 |
|
Senior Member
Join Date: Jul 2009
Location: Northants
Posts: 2,312
|
BSI sounds a favourite.
__________________
If if doesn't increase acceleration, improve handling or bring me sexual gratification then I'm not interested! |
|
|
|
|
|
#3 |
|
Super Moderator
Join Date: Mar 2009
Location: Northern Ireland
Posts: 7,746
|
Welcome Pearse , any bad earth problems ? connections under drivers carpet are usually down to wetness carried in on the feet, have you got "planet" to see if the keys are still been seen ?
Where abouts in Tyrone are you ? Mum`s family are from Dromore and i was down that way on Saturday , just got to McDonalds in Omagh before the football crowd landed after the match.
|
|
|
|
|
|
#4 |
|
Junior Member
Join Date: Jul 2011
Posts: 3
|
thanks guys for comments
im from loughmacrory Omagh what is the ''Planet'' ??? does bsi switch/control dash clocks etc can i buy new bsi and just swap or need to program or buy new corresponding bsi and ecu and drop in? no bad earths as such |
|
|
|
|
|
#5 |
|
Senior Member
Join Date: Apr 2011
Posts: 117
|
Hi pearse did you check earthing point down below the relay switches black box lifts out just beside battery i had problems too and was down to that earth point also im in dungannon and have peugeot planet if ya need any other help
|
|
|
|
| Sponsored Links | |
Advertisement | |
![]() |
| Thread Tools | |
| Display Modes | |
|
|