307 abs fault

ice203 · 10-31-2009, 03:52 PM

hi. i have a 2003 307 1.4hdi and the abs light comes on at 30mph. i had it pluged into a computer and it said rear senors are faulty. so i replaced them and both wheel bearing and still i have this light come on.
any surgestions.
thxs

bluetyler · 10-31-2009, 04:26 PM

Might need the gap cleaning of corrosion. Where the abs sensor is screwed in there will be a build up of corrosion.

ice203 · 10-31-2009, 04:45 PM

both bearings and sensors are new so no corrosion.

bluetyler · 10-31-2009, 06:44 PM

I know but where the sensors are mounted on the hub there is always a build up of corrosion, done plenty before.

ice203 · 12-01-2009, 03:28 PM

cleaned hubs and sensors up and now the abs light comes on straight away before i even drive off,

my question now is, what should the cap be between the sensor and the hub and how do you adjust it,

thxs

bigboots · 12-20-2009, 10:56 AM

it should just set itself for the gap.or try putting a thin washer behind it.

10-31-2009, 03:52 PM	#1
ice203 Junior Member Join Date: Oct 2009 Posts: 4	307 abs fault hi. i have a 2003 307 1.4hdi and the abs light comes on at 30mph. i had it pluged into a computer and it said rear senors are faulty. so i replaced them and both wheel bearing and still i have this light come on. any surgestions. thxs Share Share this post on Digg Del.icio.us Technorati Twitter

10-31-2009, 04:26 PM	#2
bluetyler Senior Member Join Date: Jun 2009 Location: Rawdon, W.Yorks Posts: 279	Might need the gap cleaning of corrosion. Where the abs sensor is screwed in there will be a build up of corrosion. Share Share this post on Digg Del.icio.us Technorati Twitter

10-31-2009, 04:45 PM	#3
ice203 Junior Member Join Date: Oct 2009 Posts: 4	both bearings and sensors are new so no corrosion. Share Share this post on Digg Del.icio.us Technorati Twitter

10-31-2009, 06:44 PM	#4
bluetyler Senior Member Join Date: Jun 2009 Location: Rawdon, W.Yorks Posts: 279	I know but where the sensors are mounted on the hub there is always a build up of corrosion, done plenty before. Share Share this post on Digg Del.icio.us Technorati Twitter

12-01-2009, 03:28 PM	#5
ice203 Junior Member Join Date: Oct 2009 Posts: 4	cleaned hubs and sensors up and now the abs light comes on straight away before i even drive off, my question now is, what should the cap be between the sensor and the hub and how do you adjust it, thxs Share Share this post on Digg Del.icio.us Technorati Twitter

12-20-2009, 10:56 AM	#6
bigboots Senior Member Join Date: Aug 2009 Posts: 198	it should just set itself for the gap.or try putting a thin washer behind it. Share Share this post on Digg Del.icio.us Technorati Twitter

Remove Advertisements Sponsored Links
PeugeotForums.com Advertisement

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode