A little help if you will?

[JipMeg101]

Ok, so I have a 53 plate 206 sw, a couple of days ago one of the rear brake cylinders gave up the ghost on my way back from work, managed to nurse the car home (the central display was reminding me brake fluid was low).

I managed to get the brake cylinder replaced and brakes bled and everything was as normal.

The next day i was going to work when I got a braking fault message on the display and the brake warning light came on, about 30 seconds later an airbag fault message came up along with the airbag light, and the speedo stopped working.

Now whenever i start the car it takes about 1 min for the braking fault light to come on and another 30 seconds for the airbag light/speedo to stop working.

Any ideas or advice is greatly appreciated

[john_h]

well the speedo gets the info from the abs/speed sensors that obviously go through the ABS module that also control the brakes.

after the abs was bled and refilled, did you get the errors reset on the computer? i know some cars have to have had this done...if you check the link in my sig to find a local member with planet. saves you a few beer tokens from going to dealer.

also they while there they can diagnose the airbag aswell

[JipMeg101]

Thanks for the quick reply John,

no i didn't get the error messages taken off the computer, but will get it done soon, hopefully this will solve the problem.

Once again cheers bud

[JipMeg101]

Well i got the car sorted just after New Year and everything was fine until yesterday, the problem has came back, I've checked all brakes, all fine, fluid is fine, fuses fine, I'm going to check the wires under the seats tomorrow does anyone have any suggestions what else i can check?